09740

Dual Ground Wrist Strap with 10' Block ?Dual wrist strap ground without resistor ?10' cord ?Two banana jacks allow two people to ground wrist straps ?Ring terminal at end of cord allows easy attachment to building ground ?Mounts under the front edge of workstation to save work space ?Two "parking studs" prevent accidental damage to cord when not in use ?Extra ring terminal included to customize cord length

CORD GRND POINT FOR DUAL ESD 10'

TB-2000 March 2012 Page 1 of 4 Installation and Maintenance of ESD Mats Introduction The purpose of an ESD worksurface is to aid in the prevention of damage to ESD sensitive components and assemblies from electrostatic discharge. An ESD worksurface provides protection in the following two ways: 1. Providing an antistatic worksurface area that will limit static electricity generation. 2. Removing the charge from a conductive object placed on the worksurface. A dissipative worksurface having a surface resistance of at least 1 x 10E6, but less than 1 x 10E9 ohms is recommended by worksurface standard ANSI/ESD S4.1. Dissipative materials minimize the generation of static charges, and will dissipate a charge slow enough so that a spark will not occur. Dissipative materials are usually the preferred choice for bench top worksurfaces. Conductive materials are the quickest to remove a charge, but they can also cause damage by discharging too rapidly. Conductive materia

TB-2000 March 2012 Page 1 of 4 Installation and Maintenance of ESD Mats Introduction The purpose of an ESD worksurface is to aid in the prevention of damage to ESD sensitive components and assemblies from electrostatic discharge. An ESD worksurface provides protection in the following two ways: 1. Providing an antistatic worksurface area that will limit static electricity generation. 2. Removing the charge from a conductive object placed on the worksurface. A dissipative worksurface having a surface resistance of at least 1 x 10E6, but less than 1 x 10E9 ohms is recommended by worksurface standard ANSI/ESD S4.1. Dissipative materials minimize the generation of static charges, and will dissipate a charge slow enough so that a spark will not occur. Dissipative materials are usually the preferred choice for bench top worksurfaces. Conductive materials are the quickest to remove a charge, but they can also cause damage by discharging too rapidly. Conductive materia

TB-2000 March 2012 Page 1 of 4 Installation and Maintenance of ESD Mats Introduction The purpose of an ESD worksurface is to aid in the prevention of damage to ESD sensitive components and assemblies from electrostatic discharge. An ESD worksurface provides protection in the following two ways: 1. Providing an antistatic worksurface area that will limit static electricity generation. 2. Removing the charge from a conductive object placed on the worksurface. A dissipative worksurface having a surface resistance of at least 1 x 10E6, but less than 1 x 10E9 ohms is recommended by worksurface standard ANSI/ESD S4.1. Dissipative materials minimize the generation of static charges, and will dissipate a charge slow enough so that a spark will not occur. Dissipative materials are usually the preferred choice for bench top worksurfaces. Conductive materials are the quickest to remove a charge, but they can also cause damage by discharging too rapidly. Conductive materia